![]() It's good to note that if the Measure tool window is collapsed, you can simply expand it by clicking on the drop-down arrow on the top right corner. To measure an edge, all that is needed is to either select two points or the entire edge. SOLIDWORKS will take care of the rest and produce the measurement. The option to just see the distance is always enabled, but if the XYZ coordinates need to be activated, simply click on the Show XYZ Measurements button to turn it on. The same rules that apply to dimension an angle in a sketch apply to use the Measure tool as well. The edges that will be used to measure an angle cannot be co-linear or parallel to one another.Īlso, it is possible to select an entire face and get its surface area, as well as getting the combined length of selected edges on a part. Now when it comes to measuring circles or arcs, it’s very important to know that it is not just limited to measuring from center to center. There are other options, such as measuring the minimum distance. All that is needed is to have both arcs selected and then click on the Arc/Circle Measurements button and change it to Minimum Distance. Once selected, it will grab the shortest distance and display the appropriate measurement. ![]() The same can be done when trying to get the maximum distance between arcs. Both arcs must be selected and then you can click on the Maximum Distance button, found under Arc/Circle Measurements, to produce the desired dimension. Of course, if a custom distance between the arcs is needed, an option is readily available in Arc/Circle Measurements.Īlthough the part might have been made using metric units, it is possible to view the dimensions in a different unit system. Inside the Measure tool window on the upper left corner, you will find a Units/Precision button. Once clicked, the Measure Units/Precision window pops up. We can leave the unit system that the part came with, or select Use custom settings. Once custom settings is active, the length unit can be changed to any standard unit available in the drop-down. If the dimensions need to be shown in scientific notation, there is an option for it. The angular unit has several options as well.Īdditionally, precision control is available at the bottom of this dialog to control how many places after the decimal the lengths will be shown. Using the Measure tool helps us produce otherwise complex measurements simply and accurately without using Smart Dimensions. When it comes to measuring arcs or circles, the center to center option can be changed to get a minimum or maximum distance. Units can be changed while using the Measure tool and not have it change the units of the part. If you have any tips or tricks on the Measure tool, let us know in the comments! For more information on SOLIDWORKS or if you have any questions, contact us at Hawk Ridge Systems today. What is eDrawings for Pro/ENGINEER? How much does it cost?.What is eDrawings Professional for Pro/ENGINEER? How much does it cost?.What's the difference between these eDrawings products and ProductView, and ProductView Express?.How does eDrawings fit in with PTC's visualization strategy?.Can files viewable by eDrawings be viewed within or managed by Windchill?.What operating systems are supported for eDrawings?. ![]() What Pro/ENGINEER versions are supported by eDrawings?.How does my customer get eDrawings or eDrawings Professional?.What applications are required to publish eDrawings files?.Is technical support offered for eDrawings?.Is there anyway to prevent anyone from measuring my eDrawings?.Will eDrawings Professional be node-locked to specific hardware?.#Edrawings viewer measure disabled professional Do I have to have Pro/ENGINEER installed on the same machine that I install eDrawings Professional?.#Edrawings viewer measure disabled install What is eDrawings for Pro/ENGINEER? How much does it cost?ĮDrawings for Pro/ENGINEER is a simple, viewing and publishing application for "fire and forget" communication of 2D and 3D CAD data. #Edrawings viewer measure disabled professional.#Edrawings viewer measure disabled install.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |